Replacing Basin Taps

Tools:

Basin Wrench:
Use a Basin Wrench to release the connector nuts securing the taps to the supply pipes.
Cranked Spanner:
Use a cranked spanner to release the back nut attaching a tap to a basin. If the nut is stiff, try putting a screwdriver through the end of the spanner to provide extra purchase. Worcester Boiler Repair London use spanners.


1). Reach up and unscrew the holding the nuts of the old taps. You will need a basin wrench to release the tap connector nuts securing the taps to the pipes, and cranked Spanner to release the back nuts securing the taps in the basin.

2). Lift out the old taps. If they won’t budge even after you have removed the holding nuts, there may be stuck in place with old putty. If so, then, tap them lightly from below with a wooden mallet. Clean the ceramic surround before fitting the new taps.

3). Secure the new taps from the underside using the washers and mounting nuts supplied. The hot tap goes on the left, and the cold tap goes on the right. Either re-attach the existing pipework or use a 15 mm flexible tap connector. Worcester Boiler Service London fit taps.

Finally, Clean any paint or tarnish from the pipes using wire wool and check there is no debris in the new taps before making the attachments. Restore the water supply and check the taps are working without any leaks.


NOTE:
Lots of new taps now have a handy ‘eco click’ mechanism that can help you and your family to develop some water wise habits. When the tap is first turned on, it will flow at a rate that is correct for rinsing a toothbrush or facecloth. If you need a higher flow rate to fill a basin for example, you increase the turn past the click.